Have you tried setting the powercfg to max in the TS? Not tried it on those, but it does move things along with most hardware. By default the powercfg in winpe is set to "easy cowboy".
Sent from a dog and bone. On 7 May 2015, at 16:22, Chris Carbone <[email protected]<mailto:[email protected]>> wrote: Has anyone else seen this issue where at specifically 52% on Setup is installing devices these NUC's just drag and drag. Each percent takes 10 - 15 minutes after it hits 52%. If you just let it go, it'll eventually finish and everything is fine but I would like to nail down what is causing this. Now I'm also using these same Intel NUC 64-bit drivers for the Quiet PC's we have. The Quiet PC's are essentially the same exact kit that these Intel NUC's are, same hardware and this problem does not happen on the Quiet PC's. I've tried different SIR drivers which I've read around the net that could be causing this. I've also turned off the consumer IR setting within BIOS and this did not change anything. And just to add more nonsense to this problem, this hanging issue doesn't always happen. I would guess around 35-40% of the time this problem comes up. Any help would be greatly appreciated as this is making me insane! This electronic mail transmission may contain confidential information intended only for the use of the individual(s) identified as addressee(s). If you are not the intended recipient, you are hereby notified that any disclosure, copying, distribution or the taking of any action in reliance on the contents of this electronic mail transmission is strictly prohibited. If you have received this transmission in error, please notify me by telephone immediately.
