On Tue, 2002-04-16 at 11:20, Phil Davey wrote:
> On Tue, 16 Apr 2002, Prakash Advani wrote:
> > Hello, this is my first post to the list. I have the following problem
> > with Intel 810 Chipset motherboard with on board AGP graphic card. I
> > have tried the following but no luck.
> >
> > 2. If I change the configuration for this particular workstation and add
> > the line
> > MODULE_01=agpgart.o
> > Then then machine doesn't hang but I don't get any display.
I have 1 workstation with onboard i810, and all I had to do was set the
XSERVER to i810 in lts.conf- as below :
[ws221]
XSERVER = i810
LOCAL_APPS = N
USE_NFS_SWAP = Y
SWAPFILE_SIZE = 48m
RUNLEVEL = 5
>From memory, XSERVER=auto did not work in this situation, but the above
did.
I assume you are using LTSP 3.0 ?
Hope this helps
David Sword
>
> Does this module actually run? You should see some output from it when it
> loads.
> For some reason, I need to *not* put the .o after module names to get
> them to load, like this:
> MODULE_01=agpgart
>
> Other than that, I can't really help. I am using a 815 motherboard with no
> problems. (fingers crossed =)
>
> --
> Phil Davey
> Computer Officer
> Hughes Hall College, Cambridge
> Email [EMAIL PROTECTED]
>
>
> _____________________________________________________________________
> Ltsp-discuss mailing list. To un-subscribe, or change prefs, goto:
> https://lists.sourceforge.net/lists/listinfo/ltsp-discuss
> For additional LTSP help, try #ltsp channel on irc.openprojects.net
--
_____________________________________________________________________
Ltsp-discuss mailing list. To un-subscribe, or change prefs, goto:
https://lists.sourceforge.net/lists/listinfo/ltsp-discuss
For additional LTSP help, try #ltsp channel on irc.openprojects.net
