Darren,
FYI, I have the same symptom with all of the eepro100 NIC's that I have tried
on my RH7.3 system. I do not use PXE.
However, I did find that by repeatedly re-starting the terminal, the eepro
would occasionally get past the 'Searching for server' point and the terminal
would then work just fine ... until the next reboot of the terminal. I could
not identify any reason for this random behaviour. I pulled them out and
installed 3C905's in their place. Pity.
--Robert
On March 6, 2003 21:51, Darren Spruell wrote:
> I've been struggling with getting eepro100 client workstations to boot
> from our RH 7.3 LTSP server, both using Etherboot floppies and setting
> the cards to PXE and booting over the network.
> .000021.0000 done
> ROM segment 0x0800 length 0x4000 reloc 0x9400
> Etherboot 5.08 (GPL) Tagged ELF for [EEPRO100]
> Boot from (N)etwork or (L)ocal? N
> Probing... [EEPRO100] Found Intel EtherExpressPro100 ROM Address 0x1800
> Ethernet addr: 00:D):B7:C3:97:45
> Searching for server (DHCP)...
> ._
>
> And stops. Once again, the only communication between the client and
> server is a DHCPDISCOVER and a DHCPOFFER - then nothing.
--
Robert March
St Andrew's House
L'Orignal ON K0B 1K0
-------------------------------------------------------
This SF.net email is sponsored by: Etnus, makers of TotalView, The debugger
for complex code. Debugging C/C++ programs can leave you feeling lost and
disoriented. TotalView can help you find your way. Available on major UNIX
and Linux platforms. Try it free. www.etnus.com
_____________________________________________________________________
Ltsp-discuss mailing list. To un-subscribe, or change prefs, goto:
https://lists.sourceforge.net/lists/listinfo/ltsp-discuss
For additional LTSP help, try #ltsp channel on irc.freenode.net
