Darren,
FYI, I have the same symptom with all of the eepro100 NIC's that I have tried on my RH7.3 system. I do not use PXE.
However, I did find that by repeatedly re-starting the terminal, the eepro would occasionally get past the 'Searching for server' point and the terminal would then work just fine ... until the next reboot of the terminal. I could not identify any reason for this random behaviour. I pulled them out and installed 3C905's in their place. Pity.
--Robert>
So has anyone else had similar experiences, but success under different RH releases?
-- Darren Spruell Sento IS Department [EMAIL PROTECTED]
On March 6, 2003 21:51, Darren Spruell wrote:
I've been struggling with getting eepro100 client workstations to boot from our RH 7.3 LTSP server, both using Etherboot floppies and setting the cards to PXE and booting over the network.
.000021.0000 done ROM segment 0x0800 length 0x4000 reloc 0x9400 Etherboot 5.08 (GPL) Tagged ELF for [EEPRO100] Boot from (N)etwork or (L)ocal? N Probing... [EEPRO100] Found Intel EtherExpressPro100 ROM Address 0x1800 Ethernet addr: 00:D):B7:C3:97:45 Searching for server (DHCP)... ._
And stops. Once again, the only communication between the client and server is a DHCPDISCOVER and a DHCPOFFER - then nothing.
-------------------------------------------------------
This SF.net email is sponsored by: Etnus, makers of TotalView, The debugger for complex code. Debugging C/C++ programs can leave you feeling lost and disoriented. TotalView can help you find your way. Available on major UNIX and Linux platforms. Try it free. www.etnus.com
_____________________________________________________________________
Ltsp-discuss mailing list. To un-subscribe, or change prefs, goto:
https://lists.sourceforge.net/lists/listinfo/ltsp-discuss
For additional LTSP help, try #ltsp channel on irc.freenode.net
