On Wed, 14 Jan 2004, [EMAIL PROTECTED] wrote: > what would cause lts.conf to not be parsed properly. Parameters in the > [Defaults] section are picked up, but changes I make under the [ws001] > sections are being overlooked?
Could be that the workstation doesn't know it's own hostname. Try putting the IP address OR the MAC address in the [ ] See if it picks that up. Jim McQuillan [EMAIL PROTECTED] > > > > > ------------------------------------------------------- > This SF.net email is sponsored by: Perforce Software. > Perforce is the Fast Software Configuration Management System offering > advanced branching capabilities and atomic changes on 50+ platforms. > Free Eval! http://www.perforce.com/perforce/loadprog.html > _____________________________________________________________________ > Ltsp-discuss mailing list. To un-subscribe, or change prefs, goto: > https://lists.sourceforge.net/lists/listinfo/ltsp-discuss > For additional LTSP help, try #ltsp channel on irc.freenode.net > ------------------------------------------------------- This SF.net email is sponsored by: Perforce Software. Perforce is the Fast Software Configuration Management System offering advanced branching capabilities and atomic changes on 50+ platforms. Free Eval! http://www.perforce.com/perforce/loadprog.html _____________________________________________________________________ Ltsp-discuss mailing list. To un-subscribe, or change prefs, goto: https://lists.sourceforge.net/lists/listinfo/ltsp-discuss For additional LTSP help, try #ltsp channel on irc.freenode.net
