On Dec 12, 2007 8:10 AM, Fajar Priyanto <[EMAIL PROTECTED]> wrote: > On Tuesday 11 December 2007 11:48:07 Fajar Priyanto wrote: > > When I setup the printer using System > Administration > Printing. > > I give the printer the name: IBM. > > Thanks for the response. > > This makes me wonder, is it possible to print to a printer attached in client1 > from client2? Or should I attach 1 printer on each client? > Thanks. > --
Of course it can print to printer attached in another client. i just wondering about your LX300 printer, you sure the printer still work fine? --snip (your lts.conf) [00:19:66:16:23:93] <-- the mac address of client1 PRINTER_0_TYPE=P PRINTER_0_DEVICE=/dev/lp0 --snip usually the client should open port 9100 as jetdirect service, you can check it using nmap if the client open that port or not. or you can try to change mac address in lts.conf section (in this case [00:19:66:16:23:93] ) to a hostname or ip address. hope it can help.. Thanks. -- Angga ------------------------------------------------------------------------- SF.Net email is sponsored by: Check out the new SourceForge.net Marketplace. It's the best place to buy or sell services for just about anything Open Source. http://sourceforge.net/services/buy/index.php _____________________________________________________________________ Ltsp-discuss mailing list. To un-subscribe, or change prefs, goto: https://lists.sourceforge.net/lists/listinfo/ltsp-discuss For additional LTSP help, try #ltsp channel on irc.freenode.net
