James send a photo of REX installed in your M100 to me if you can. thanks Steve
On Mon, Apr 20, 2015 at 7:19 AM, James Zeun <[email protected]> wrote: > Ok made this mistake of including pictures in that reply. The chip in the > later model and it is installed correctly. I've just reset / wiped my m100 > and tried the command again. My machine is just locked, I don't know if it > doing anything :-/ > On 20 Apr 2015 12:14 pm, "Stephen Adolph" <[email protected]> wrote: > >> Yep, and make sure that it is oriented correctly. There are 2 versions >> of REX for M100, and early and a current. If yours has both chips on the >> same side of the board then it is a current version. In that case the >> chips should be down and not visible when the module is installed. >> >> Steve >> >> On Mon, Apr 20, 2015 at 7:11 AM, James Zeun <[email protected]> wrote: >> >>> Hi buddy >>> >>> An unexpended vanilla M100. >>> >>> Just reading about CALL63012.. >>> On 20 Apr 2015 12:09 pm, "Stephen Adolph" <[email protected]> wrote: >>> >>>> James, what model are you installing into? >>>> ..Steve >>>> >>>> On Mon, Apr 20, 2015 at 7:05 AM, <[email protected]> wrote: >>>> >>>>> Hey everyone >>>>> >>>>> I just got my REX In the post, followed the guide on wiki as the >>>>> printed manual seems to be for an earlier module. I have it installed as >>>>> it >>>>> shown on the guide but I'm not seeing anything appearing on my menu. As I >>>>> understand it, I should see a new program listed for accessing my REX >>>>> module. Can anyone help please, I've been waiting ages for this to arrive, >>>>> I dont want to think it's arrived DOA. >>>>> >>>>> Cheers >>>>> James >>>> >>>> >>>> >>
