Yes, of course, you’re correct. I’m not getting to that point anyway. I appreciate any help you can provide, Brian.
I’m following the steps in every manual I’ve found. If I’m missing a step it’s certainly not obvious in the steps as I understand them. I assumed that if that if the DVI booted to the Microsoft screen the drive and disk were good. The issue is here that when the M100 is restarted nothing happens on the DVI. No reaction at all. The drive does not light up and does not attempt to read the disk to load BASIC. Thanks > On Jan 26, 2018, at 4:51 PM, Brian White <[email protected]> wrote: > > "and the screen of the M100 is now routed to the monitor" > > The screen is only switched to the monitor if you issue the command in basic > to do it. > > SCREEN 1,1 > > I'll record a video tonight of the boot process just to remove all question > marks if you're doing everything right. > The steps are spelled out exactly in the user manual though. > Jump to page 11 > http://www.classiccmp.org/cini/pdf/Tandy/Disk%20Video%20Interface%20Manual.pdf > > <http://www.classiccmp.org/cini/pdf/Tandy/Disk%20Video%20Interface%20Manual.pdf> > > I'll show the symptoms if the disk drive is bad too, where the dvi rom boots > itself ok so you get the first few messages on the monitor, and the drive > does run on que, but fails to actually read the disk. > > -- > bkw >
