https://youtu.be/Mt6AmyLKkXQ
Sorry you can't read the screens and I blather too much. But it shows the full working procedure, so you can satisfy yourself that we aren't doing anything different from each other. On Jan 26, 2018 11:43 AM, "Randall Kindig" <[email protected]> wrote: > hi, all, > > I’m having an issue with my DVI box and was hoping someone on this list > could point me in the right direction or had suggestions. > > I have a really clean DVI I recently purchased. The picture showed that > it booted to the initial screen off of the boot disk, so I assumed the > drive and the DVI itself were good. The seller did not misrepresent it. > They showed it booting to the initial screen and did not test it further > with an M100 and DVI cable. > > I got a cable and boot disks (with backup disk as well) from someone else > that was tested to be good. > > When I hooked up the M100 and cable to the DVI, it indeed booted off of > the disk. At that point, you reset the M100 and it’s then supposed to load > further software off the disk and the screen of the M100 is now routed to > the monitor, with more columns and rows. > > However, when I reset the M100 nothing happens. It doesn’t matter whether > I soft reset or hard reset. > > To verify this setup further, I bought a second M100 and tried it to take > that out of the equation. No difference. > > I then got a second cable from the gentlemen who was making the cables to > make sure the cable wasn’t the issue. No difference. > > I can only conclude that there’s some inside the DVI box. The tests point > to the fact that all other parts of the chain are fine: M100, cable, disks, > disk drive. > > Does anyone have any experience with the DVI box? I have the electronic > form of the service manual, but it gets into electronic troubleshooting for > which I don’t have the skills or experience. > > Any help would be much appreciated. > > Randy kindig > > > > >
