Cable assemblies made of 40-wire rainbow ribbon with individual single
dupont pins on each wire are cheap all over the place on ebay and
aliexpress. You could get male-male 40-wire assemblies and just cut them
in half. every 3 wires would be a different set of 3 colors, and none of
them would be polarized. Mostly they are short cables though, so I;m not
sure if anyone makes them long enough that when you cut them in half
they are long enough to reach wherever they need to go inside the M100.
aha... go on ebay or aliexpress and search by "servo cable" or "1000mm
servo extension"
Not polarized if you need all 3 positions. Most are short, but they are
available in various lengths up to 100cm from multiple sellers. Change
the sort to nearest first and you don't have to wait for China but pay a
little more.
https://www.ebay.com/itm/282815153348/
https://www.ebay.com/itm/291408436349/
Just a start, I'll poke around some more.
--
bkw
On 8/10/19 6:39 PM, Stephen Adolph wrote:
Good idea.
Would like to sort out how to purchase ready made 3 wire leads that
plug into a header...any ideas?
On Saturday, August 10, 2019, Brian K. White <[email protected]
<mailto:[email protected]>> wrote:
On 8/10/19 1:29 PM, Stephen Adolph wrote:
With all the large parts on one side.. it is actually a bit
hard to find places for vias for external signals.
If there's nothing on top, you could just solder a surface mount
header on top. But then so much for simplifying the manufacturing.
Though I'd still want to solder pin headers into the vias anyway
just so it's removable, so what's the difference?
Thinking out load, not a challenge.
--
bkw
