Thank you for sharing this! I have been needing a cover for my DVI cable Sent from my iPad
> On 6 Oct 2020, at 12:35 am, Peter Noeth <[email protected]> wrote: > > > With all this "Design Sharing" going around here :-) I decided to upload > the Option ROM Compartment Covers I designed for 3D Printing on Thingiverse. > There are three, a blank cover and two with cable slots for those of you with > DVIs. > Blank Cover (replacement): https://www.thingiverse.com/thing:4616011 > Cover w/ System Bus Cable Slot: https://www.thingiverse.com/thing:4616079 > Cover w/ System Bus ZIF Socket: https://www.thingiverse.com/thing:4616062 > I use the third one for my development Model 100. The ZIF connector makes it > easier to attach / remove the cable to the solderless breadboard I have been > using lately (for an Atari Joystick Interface for the 100/102/200). > > I have also made dust covers for all connectors on the 102, but I haven't > tested all of them on the Model 100 yet. I may upload these designs at a > later time. > > Regards, > > Peter >
