Hello all!
Today I finally tried to install REXCPM in my M100. I have not yet succeeded. Any suggestions would sure be appreciated. Here is the scenario: Using a Null Modem cable, I transferred the RXCINI.DO file carefully to the M100. I used 1200baud with TeraTerm on my Dell Win10 laptop, 8 bits, etc. My Dell Win10 machine came with a Dell external device that provides supports legacy ports via USB cable to an external box with physical serial, parallel, Ethernet, and USB connections. The transfer was successful and I looked at the lines of code in the .DO file and compared to a screen listing of RXCINI (used Notepad). All good. I connect my NADSbox with RXC_11.BR AND RXCINI.DO In the root directory and using the cable that I have always used with my NADSbox. Then I start through the steps found onthe Bitchin100 page: http://bitchin100.com/wiki/index.php?title=REXCPM I at step 4, I select Yes to both options, and Y to proceed. I see a line on my screen that shows dots appearing: Loading at: 62000 <......... .. Note that I see only two dots on the last line then the screen goes off with the M100 powered off. When I turn it back on, it is apparent that a cold start has occurred. I have repeated all the steps carefully at least 4 times (Cold started M100, transfer RXCINI.DO, RUN"RXCINI". I never get to step 6. The result is always the same. I am pretty sure that my transfer of RXCINI.DO is not corrupted. Any suggestions? Thanks in advance, Bob
