I had an experience where the file simply wasn't transferred correctly (7 bit), and it crashed. Not sure what to say Bob. Did you try checking that all springs are making good contact?
I test every REXCPM with each mated adapter and cable before I send it out. Try loading Teeny.do, create teeny.co and use that to load rxcini.do. On Saturday, November 14, 2020, <[email protected]> wrote: > Steve, > > > > I successfully transferred the RXCTST.DO file and ran it. > > Same kind of a message as before, but it gets to 4 dots on the second line > before the machine turns off. Turning the power on shows the results of a > cold start. Same kind of failure as with RXCINI. > > > > Before each try, I cold started the machine and cycled the power. > > > > Still stuck. > > > > Sorry, > > Bob > > > > *From:* M100 <[email protected]> *On Behalf Of *Stephen > Adolph > *Sent:* Saturday, November 14, 2020 7:37 PM > *To:* [email protected] > *Subject:* Re: [M100] STRUGGLING to get REXCPM loaded > > > > If you continue to struggle, try this: > > > > http://bitchin100.com/wiki/index.php?title=REXCPM#Test_ > your_REXCPM_Installation > > > > On Sat, Nov 14, 2020 at 7:35 PM Stephen Adolph <[email protected]> > wrote: > > Hi Bob, > > my guess is that there are one of 2 things wrong. > > 1) the socket has some loose connections or > > 2) the 8 bit transfer didn't go as planned and there is something amiss > with RXCINI.DO > > > > I must say, I need to make my utilities more bulletproof. I think I will > adopt the Ron Weisen encoding...7 bit. > > > > Steve > > > > On Sat, Nov 14, 2020 at 4:06 PM <[email protected]> wrote: > > Hello all! > > > > Today I finally tried to install REXCPM in my M100. I have not yet > succeeded. Any suggestions would sure be appreciated. Here is the > scenario: > > > > Using a Null Modem cable, I transferred the RXCINI.DO file carefully to > the M100. I used 1200baud with TeraTerm on my Dell Win10 laptop, 8 bits, > etc. My Dell Win10 machine came with a Dell external device that provides > supports legacy ports via USB cable to an external box with physical > serial, parallel, Ethernet, and USB connections. > > > > The transfer was successful and I looked at the lines of code in the .DO > file and compared to a screen listing of RXCINI (used Notepad). All good. > > > > I connect my NADSbox with RXC_11.BR AND RXCINI.DO In the root directory > and using the cable that I have always used with my NADSbox. Then I start > through the steps found onthe Bitchin100 page: > > http://bitchin100.com/wiki/index.php?title=REXCPM > > > > I at step 4, I select Yes to both options, and Y to proceed. > > I see a line on my screen that shows dots appearing: > > Loading at: 62000 <……………………. > > .. > > Note that I see only two dots on the last line then the screen goes off > with the M100 powered off. When I turn it back on, it is apparent that a > cold start has occurred. > > > > I have repeated all the steps carefully at least 4 times (Cold started > M100, transfer RXCINI.DO, RUN”RXCINI”. I never get to step 6. The result > is always the same. > > > > I am pretty sure that my transfer of RXCINI.DO is not corrupted. > > > > Any suggestions? > > > > Thanks in advance, > > Bob > >
