Teeny?

On Thursday, July 8, 2021, Tom Wilson <wilso...@gmail.com> wrote:

> Right, you don’t need TS-DOS, but you need *something* with the ability
> to load files from a TPDD compatible device. If you have an actual TPDD,
> you can use the bootstrap function, otherwise you have to find a program
> that can be used to bootstrap the necessary files.
>
> That was the challenge - finding a program that could do the job on the
> T200.
>
> On Thu, Jul 8, 2021 at 4:05 PM Josh Malone <josh.mal...@gmail.com> wrote:
>
>> I've been informed that you don't actually need TS-DOS loaded to flash
>> a REX -- just something to load the flash utility. Teeny will do.
>>
>> On Thu, Jul 8, 2021 at 6:38 PM Tom Wilson <wilso...@gmail.com> wrote:
>> >
>> > Yes, I have flashed a Rex Classic to work on a 200. It’s a PITA, mostly
>> to get the DOS boot loader on so I can get the TS-DOS ROM loaded. The
>> problem being that with only 24K of RAM per bank, it’s hard to find a BASIC
>> loader small enough to do the job.
>> >
>> > If you need me to, I can dig through my archive and find the program I
>> used.
>> >
>> > On Thu, Jul 8, 2021 at 1:18 PM Josh Malone <josh.mal...@gmail.com>
>> wrote:
>> >>
>> >> REX classic and REX# come in 2 "flavors": 100/102 and 200
>> >>
>> >> The hardware is physically identical, as is the CPLD program. However,
>> >> the FLASH load is different, owing to the different memory
>> >> configurations/maps on the 2 systems. You can "reprogram" a 100/102
>> >> into a 200 and vice-versa by following the initial programming steps
>> >> and doing a "wipe and reload". At least, you can on the REX classic.
>> >> I've never done it on REX# so check the wiki pages.
>> >>
>> >> -Josh
>> >>
>> >> On Thu, Jul 8, 2021 at 2:55 PM Bill Miranda <bill.mira...@gmail.com>
>> wrote:
>> >> >
>> >> > Is REX module interchangeable between model 100 and model 102?
>> >> >
>> >> > Thanks!
>> >> >
>> >> > Bill
>> >
>> > --
>> > Tom Wilson
>> > wilso...@gmail.com
>> > (619)940-6311
>> >
>>
> --
> Tom Wilson
> wilso...@gmail.com
> (619)940-6311
>
>

Reply via email to