Is it possible that your CTRL or BREAK key are not working, thus you are not able to do a cold reset? It could also be the M2 data bus latch has the bit you mentioned stuck. Sometimes you can look at a suspect bit on the oscilloscope and see incorrect voltage levels, or what looks like multiple signals at once. Note that with the multiplexed bus this can be difficult to spot as there are some ‘normal’ goofy looking waveforms when the bus is being multiplexed.
The code for the test harness test ROM is here: https://github.com/Jeff-Birt/TRS-80-M100-M102-Test-Harness . The test harness ROM board has a small built in LCD for feedback. You won’t have this but you can follow how far it gets though the test with your LA. Jeff Birt From: M100 <[email protected]> On Behalf Of Eric Sent: Wednesday, January 3, 2024 10:23 AM To: [email protected] Subject: Re: [M100] Model 100 - LCD Shows Pixels Only Yes, I did hold down CTRL+BREAK+press reset. Repeated this three times and the data is almost identical (repeatable results). I triggered off of the reset signal and recorded 100ms pre-trigger and 2s post-trigger. Performed data review just after the RESET occurred. Thanks again for everyone's help with this. I'm learning a lot about this computer and feedback from the forum has been very inspiring! On Wednesday, January 3, 2024 at 05:12:15 AM PST, < <mailto:[email protected]> [email protected]> wrote:
