Hi, I am trying to run the Splash2 in Chip MultiProcessors using SE mode. I get the Splash2 binary in the following link. http://www.m5sim.org/dist/m5_benchmarks/v1-splash-alpha.tgz
I can run SPLASH2 in Simple 4 CPU cores using default .py file (m5_1.1/m5/configs/splash2/run.py) But Simulation isn't finished in Detailed 4 CPU cores. Could you tell me how to run Splash2 benchmarks ? following line is my comand line message and m5stat.txt ##### comand line messege ###### command line: ./m5.fast -ENP=4 -d output_splash_nofft/ ../../../m5-test/splash2/run_no.py -ESYSTEM=Detailed -EBENCHMARK=FFT -EROOTDIR=/home/fukumoto/m5_1.1/m5-test/splash2/splash2/codes/ warn: Entering event queue. Starting simulation... ##### m5stat.txt ###### cpu0.COM:IPC 0.007785 # Committed instructions per cycle cpu0.FETCH:idle_rate 99.71 # percent of cycles fetch stage was idle toL2Bus.addr_idle_fraction 0.010075 # fraction of time addr bus was idle toL2Bus.data_idle_fraction 0.010104 # fraction of time data bus was idle toMemBus.addr_idle_fraction 0.010267 # fraction of time addr bus was idle toMemBus.data_idle_fraction 0.009773 # fraction of time data bus was idle Thanks and Best Regards, Naoto Fukumoto <[EMAIL PROTECTED]> _______________________________________________ m5-users mailing list [email protected] http://m5sim.org/cgi-bin/mailman/listinfo/m5-users
