My Delta Printer with BBB rev C, BeBoPr++ and pepper board print in a very consistent way dimensional failures. The slicer I use is Slic3R
Test parts of 40x80x3 mm or 100x100x5 mm all do endup with the same dimensional failures. Print speed has no influence on the dimensional failures. (Printed at 80 mm/sec) Mechanical variables I did I eliminate or minimized: 1. Renewed the arms; Arm length (292) tolerance Center to Center within 0.03 mm 2. Real play in joints is near to "0" (Magnet joints) 3. Bearing blocks play, near to "0" 4. Build Bed Leveling within 0.03 mm 5. The poles are dead square to the build bed What is exact the failure I can observe: When printing a straight line that is centered on the bed plate, just over the center of the line the line seems to make a jump of 0.25 mm; printing a rectangular shape mean that exact the same happens again on the opposite side of the first straight line. (See picture 40x80x3mm) It happen only along the X-Axis, the Y-axis is nicely straight. In general holes are not round. (~0.3 mm) Has anyone an idea what is going on here? Is it the linear delta algorithm that fools me or is it me doing something terrible wrong here? Need help, please <https://lh3.googleusercontent.com/-1lwR-IcJddY/V2z5MhtCWJI/AAAAAAAACkY/H5jnJxEJNbEE5HMKn-iwNSMgLEzPcyz8ACLcB/s1600/Print%2BDelta%2Bprinter%2B2.jpg> -- website: http://www.machinekit.io blog: http://blog.machinekit.io github: https://github.com/machinekit --- You received this message because you are subscribed to the Google Groups "Machinekit" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. Visit this group at https://groups.google.com/group/machinekit. For more options, visit https://groups.google.com/d/optout.
