so it loads without error now but if i command any rpm it says 0 rpm, maybe could be because i have no encoder mounted at the time
Am Montag, 26. September 2016 10:25:32 UTC+2 schrieb Schooner: > > > On 26/09/16 09:11, [email protected] <javascript:> wrote: > > > On 25/09/16 20:55, Sag ich Dir nich wrote: > > > > *4.* then i created a new file in the machine directory and named it " > spindle_to_pyvcp.hal" in which i copied "net spindle-rpm-filtered => > pyvcp.spindle-speed". > > i am assuming that "net spindle-rpm-filtered" is the signal > > > No good assuming, if you didn't create it, it does not exist > > so i tried using other pins but everytime i get an error message "pin does > not exist". > > > The correct signal is annotated in your hal file > > *# For display in pyvcp * > *net smoothed_rpm spindle-rpm-filter.out * > > > > > hal_xinit:171 HAL error: duplicate component name 'hal_manualtoolchange' > > but i havent touched it so why would it duplicate then? > > > You are loading it right at the start of cramps.hal > > *loadusr -W hal_manualtoolchange* > > and loading it again by including > > *HALFILE = axis_manualtoolchange.hal* > > in your ini file > > > PS. > > Remove the line loading hal_manualtoolchange at the start of the > cramps.hal file and leave the axis_manualtoolchange.hal > line in your ini file > You are loading it, but not doing anything with it in the cramps.hal file > > hal_manualtoolchange is normally loaded at the end of a hal file, one of > the reasons is that it relies upon iocontrol, > which is a userspace module and may not be immediately available. > See the connections in the axis_manualtoolchange.hal file > > It certainly should not be loaded before even kinematics, trajectory > planner and threads have been loaded > > > -- > website: http://www.machinekit.io blog: http://blog.machinekit.io github: > https://github.com/machinekit > --- > You received this message because you are subscribed to the Google Groups > "Machinekit" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected] <javascript:>. > Visit this group at https://groups.google.com/group/machinekit. > For more options, visit https://groups.google.com/d/optout. > > > -- website: http://www.machinekit.io blog: http://blog.machinekit.io github: https://github.com/machinekit --- You received this message because you are subscribed to the Google Groups "Machinekit" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. Visit this group at https://groups.google.com/group/machinekit. For more options, visit https://groups.google.com/d/optout.
