> On 31 Aug 2017, at 13:28, Pranav Pandey <[email protected]> wrote: > > well, the first line states your problem. A file isn’t found. so you probably > have a path problem. > please do read these informations carefully. because it will give you clues. > > to get the location of the file (which should be available) on your system > type > in the terminal: “sudo find / -name g22.ngc” > > now before you start please do in the terminal “export DEBUG=5” > > run machinekit > > Done. The issue has been eliminated by using the following CRAMPS Config. > https://github.com/machinekoder/MendelMax-CRAMPS/blob/master/CRAMPS.ini > > But now on importing the g-code I get the following errors: > > user-defined M190: missing: P
It clearly states you are missing a ‘P’ argument so take a look at your g-code where M190 is used and see if it has a P argument > > I found this information on the linuxcnc page regarding this error: > > Assume the code is defined as > > REMAP=M400 modalgroup=10 argspec=Pq ngc=m400 > and m400.ngc looks as follows: > o<m400> sub > (P is required since it's uppercase in the argspec) > (debug, P word=#<P>) > (the q argspec is optional since its lowercase in the argspec. Use as > follows:) > o100 if [EXISTS[#<q>]] > (debug, Q word set: #<q>) > o100 endif > o<m400> endsub > M2 > executing M400 will fail with the message user-defined M400: missing: P > > executing M400 P123 will display P word=123.000000 > > executing M400 P123 Q456 will display P word=123.000000 and Q word set: > 456.000000 > > In my case I opened the M190.ngc file which looked like this > > o<m190> sub > #502=0; hbp index > M68 E#502 Q#<P> > M66 P#502 L3 Q1000 > o<m190> end sub > > Also the REMAP code is defined as > > REMAP=M190 modalgroup=10 argspec=P ngc=m190 > > What can be a possible reason for this error? > > -- > website: http://www.machinekit.io <http://www.machinekit.io/> blog: > http://blog.machinekit.io <http://blog.machinekit.io/> github: > https://github.com/machinekit <https://github.com/machinekit> > --- > You received this message because you are subscribed to the Google Groups > "Machinekit" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected] > <mailto:[email protected]>. > Visit this group at https://groups.google.com/group/machinekit > <https://groups.google.com/group/machinekit>. > For more options, visit https://groups.google.com/d/optout > <https://groups.google.com/d/optout>. -- website: http://www.machinekit.io blog: http://blog.machinekit.io github: https://github.com/machinekit --- You received this message because you are subscribed to the Google Groups "Machinekit" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. Visit this group at https://groups.google.com/group/machinekit. For more options, visit https://groups.google.com/d/optout.
