Dear All,
Some while back I undertook work to split out machinekit into its HAL
stack and its CNC stack.
This work has reached maturity, to an extent that if the machinekit-hal
package is installed and then the machinekit-cnc package is installed,
a fully functioning machinekit is available, in tests thus far anyway :)
In preparation for a two package distribution, the existing open Issues
in machinekit have been copied to either machinekit-hal, or
machinekit-cnc (in a few cases both, with a master issue in
machinekit-cnc, where they apply to both).
There were 6 exceptions, which were too large to copy over without
risking data loss and remain in machinekit.
The remaining Open Issues are now Closed, with a reference to the new
location to be used for future comment.
So, if you have opened, contributed to or just read an Issue in
machinekit, it can now be found in either
machinekit-hal: https://github.com/machinekit/machinekit-hal/issues
or
machinekit-cnc: https://github.com/machinekit/machinekit-cnc/issues
If you wish to open an issue, please do so in the appropriate repos
Issues section
If unsure which repo it should come under, generally a look through the
source files should tell you, there are no duplicates between the repos
regards actual code.
If still unsure just ask.
If you wish to test the machinekit-hal and / or machinekit-cnc packages,
please do so, they are available in the main machinekit repo.
Any feedback gratefully received.
regards
--
website: http://www.machinekit.io blog: http://blog.machinekit.io github:
https://github.com/machinekit
---
You received this message because you are subscribed to the Google Groups "Machinekit" group.
To unsubscribe from this group and stop receiving emails from it, send an email
to [email protected].
Visit this group at https://groups.google.com/group/machinekit.
For more options, visit https://groups.google.com/d/optout.
