Hi, Stepconf does not work for making a configuration for the Beaglebone. It’s easier to take an existing configuration for a Beaglebone setup and modify for your situation.
Bas > On 7 Nov 2018, at 11:36, Gediminas Dirma <gediminas.di...@gmail.com> wrote: > > Hello > > I am new to machinekit and i have some problems with stepconfig. After i > setup my configuration for lathe and i start it, it doesnt work. Then i read > why it stopped it says because my_lathe.hal and the line is 'setp > parport.0.reset-time 5000'. Than i comment this line i can launch my config. > So what does this line mean, can i leave it commented or maybe i should > change something. > > Thanks for help. > -- > website: http://www.machinekit.io blog: http://blog.machinekit.io github: > https://github.com/machinekit > --- > You received this message because you are subscribed to the Google Groups > "Machinekit" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to machinekit+unsubscr...@googlegroups.com. > Visit this group at https://groups.google.com/group/machinekit. > For more options, visit https://groups.google.com/d/optout. -- website: http://www.machinekit.io blog: http://blog.machinekit.io github: https://github.com/machinekit --- You received this message because you are subscribed to the Google Groups "Machinekit" group. To unsubscribe from this group and stop receiving emails from it, send an email to machinekit+unsubscr...@googlegroups.com. Visit this group at https://groups.google.com/group/machinekit. For more options, visit https://groups.google.com/d/optout.