Hi, Just installed Machinekit to a rpi3b+ via apt-get and I am running through the tutorial here:
http://www.machinekit.io/docs/hal/tutorial/#introduction-a-id-sec-tutorial-intro-a The strange issue: When I instantiate the siggen component, all of the pins, signals, and parameters for the component appear as 'Pins'. For example, after instantiation, when I type halcmd: show pin Component Pins: Comp Inst Type Dir Value Name Epsilon Flags linked to: 78 float IN 5 siggen.0.amplitude 0.000010 --l- 78 bit OUT TRUE siggen.0.clock --l- 78 float OUT 0.8441676 siggen.0.cosine 0.000010 --l- 78 float IN 1 siggen.0.frequency 0.000010 --l- 78 float IN 0 siggen.0.offset 0.000010 --l- 78 float OUT 2.78 siggen.0.sawtooth 0.000010 --l- 78 float OUT -4.922822 siggen.0.sine 0.000010 --l- 78 float OUT 5 siggen.0.square 0.000010 --l- 78 float OUT 0.56 siggen.0.triangle 0.000010 --l- 78 s32 OUT 5261 siggen.0.update.time ---- 78 s32 I/O 65155 siggen.0.update.tmax ---- 78 bit OUT FALSE siggen.0.update.tmax-inc ---- 66 s32 OUT 999411 test-thread.curr-period ---- 66 s32 OUT 5261 test-thread.time ---- 66 s32 I/O 65155 test-thread.tmax ---- halcmd: And when I attempt to see the parameters, nothing shows up: halcmd: show param Parameters: Comp Inst Type Dir Value Name halcmd: Also, when I run the halmeter, all items show up under the 'Pins' tab and no items show up under the Signals or Parameters tab (see image) Any thoughts? Thanks and best regards, Scott -- website: http://www.machinekit.io blog: http://blog.machinekit.io github: https://github.com/machinekit --- You received this message because you are subscribed to the Google Groups "Machinekit" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. Visit this group at https://groups.google.com/group/machinekit. For more options, visit https://groups.google.com/d/optout.
