Thank you so much！ Best Regards Wade Xu 在2020年8月11日星期二 UTC+8 下午10:16:15<[email protected]> 写道：
> Yes, the Machinekit-CNC@master cannot be currently built on top of > Machinekit-HAL@master. This was done because the original build flow was > extremely inflexible and the precedence was given to option to build > Enhanced Machine Controller (which is developed as part of LinuxCNC and the > development is much more active than Machinekit's own CNC portions). This > is now possible - https://github.com/machinekit/emcapplication and can be > previewed by following instructions here: > https://github.com/machinekit/EMCApplication/issues/1#issue-666660311 . > > I am hoping that Machinekit-CNC will be again buildable on Machinekit-HAL > after CMake build system switch, which should filter out problems stemming > out from kernel-space module past and streamline the whole operation. > > Cern. > > > Aug 11, 2020, 11:23 by [email protected]: > > > I also encountered the same problem 。I‘ll try this check out later。 > > You just solved this problem by check out commit id？ > > > > 在 2020年6月21日星期日 UTC+8上午1:14:17，Michael Labuda写道： > > > >> Hello, > >> > >> I am setting up a development environment and trying to build > machine-kit from source, I was able to build machinekit-hal without any > problems, but machinekit-cnc is a different story. Following instructions > given on >> https://www.machinekit.io/>> docs/developing/machinekit->> > developing/#get-source-and->> build>> I encountered problems immediately as > there is no build_with_cnc script included in the machinekit git. I found > this script in someone else's repo and copied it over. It started to > compile but then failed after it couldn't find > /machinekit-cnc/src/libnml/>> nml/inifile.XX. These appear to be symlinks > to some fakeinclude directory. I put in some dummy empty inifile.XX files > which got me a bit further but other source files are actually attempting > to use an Inifile class that doesn't exist. What's going on here? Did I > clone the wrong repo or something? > >> > >> Thanks, > >> Michael > >> > > > > > > > > -- > > website: > http://www.machinekit.io> blog: > http://blog.machinekit.io> > github: > https://github.com/machinekit > > --- > > You received this message because you are subscribed to the Google > Groups "Machinekit" group. > > To unsubscribe from this group and stop receiving emails from it, send > an email to > [email protected]> . > > To view this discussion on the web visit > > https://groups.google.com/d/msgid/machinekit/2846e9a6-95ea-486f-abcf-44e958b00798o%40googlegroups.com > > < > https://groups.google.com/d/msgid/machinekit/2846e9a6-95ea-486f-abcf-44e958b00798o%40googlegroups.com?utm_medium=email&utm_source=footer>> > > . > > > > -- website: http://www.machinekit.io blog: http://blog.machinekit.io github: https://github.com/machinekit --- You received this message because you are subscribed to the Google Groups "Machinekit" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion on the web visit https://groups.google.com/d/msgid/machinekit/2f05da8e-79ad-40ff-8bcb-b307578f71b2n%40googlegroups.com.
