> > You can usually configure the DHCP function to serve a range of > addresses. Set this range to something less than the total address > range supported by the NAT. Set your Web Server to an IP address > outside the DHCP range. >
Ok I tryed that and I was able to see all computers on the network but couldn't access the internet? The linksys help pages says in order to use port forwarding DHCP has to be disabled but when I disable DHCP and manually assign IP address I can not access the internet. Right now I have it set back to DHCP and have the IP address for the web server set for DMZ host leaving it open to the internet so this should work. But I tryed using my PB and dialing up so I'm not on the network and tryed accessing the static IP address should get the web server but it fails -- MacNetwork is sponsored by <http://lowendmac.com/> and... XRouter Pro | Share your DSL or cable modem between multiple computers! Dr. Bott | Only $199 <http://www.drbott.com/prod/MIH130.html> Now shipping! Farallon Wireless SkyLINE PCI Card for Mac Desktops! <http://www.farallon.com/le/skyline/pci/index.html> Support Low End Mac <http://lowendmac.com/lists/support.html> MacNetwork list info: <http://lowendmac.com/lists/macnet.html> Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive: <http://www.mail-archive.com/macnetwork%40mail.maclaunch.com/> Using a Macintosh? Get free email and more at Applelinks! <http://www.applelinks.com>
