On Sun, Apr 12, 2009 at 05:25:36PM -0500, Bill Hernandez said: > Bryan, > > The earlier results, in my previous message were from my Tiger Server. > > When I tried to install trac on the server last night, it installed > python26. > > I installed trac on my iMac about a week ago, and it installed python25. > Today when I checked 'outdated' it did not show trac even though it does > not have python26. It appears that even though trac is now installing > python26, $ 'port outdated' does not find trac on my iMac workstation as > needing upgrading ?
trac was updated [1] to use python26 recently, so make sure everything is up to date; 0.11.4 is the trac version in both cases, but revision 1 is where python26 became the preferred python. > > At about the same time I also tried to install trac on the Tiger Server, > and the installer was not successful installing trac, but it did get > python25 installed. > > On my Server, now trac has successfully installed both pythons 25 and 26, > and no trac. Any suggestions ? > > Maybe I should try to uninstall python25 to see if MaPorts squaks ? That would most likely fail since there are still quite a few ports which are 2.5-based instead of 2.6. > > > These are from my iMac Leopard Workstation. I tried you suggestion using > 'sudo port upgrade outdated' but the installer did not seem to like that > idea ? > > $ port installed (the results are at the bottom of the page) > $ port outdated > $ sudo port upgrade outdated > > which failed with an error... > > [2009.12.04](04:52PM) -> [roscoe] ~ $ port outdated > The following installed ports are outdated: > cyrus-sasl2 2.1.21_0 < 2.1.22_0 > > [2009.12.04](04:52PM) -> [roscoe] ~ $ sudo port upgrade outdated > Password: > ---> Configuring cyrus-sasl2 > Error: cyrus-sasl2 will not build when another version is active. > Error: Please deactivate or uninstall cyrus-sasl2, and then install > Error: the new version with `sudo port install cyrus-sasl2`. > Error: Target org.macports.configure returned: cyrus-sasl2 upgrade failed This is an issue with the cyrus-sasl2 port; some software doesn't build cleanly when an earlier version is available, hence this needs the older version deactivated or uninstalled prior to getting the latest version. I usually just force uninstall the old one then install the new one: $ sudo port -f uninstall cyrus-sasl2 $ sudo port install cyrus-sasl2 Bryan [1] - <http://trac.macports.org/changeset/49378> [...] _______________________________________________ macports-users mailing list [email protected] http://lists.macosforge.org/mailman/listinfo.cgi/macports-users
