On Mar 20, 2012, at 5:14 PM, Ryan Schmidt wrote: > > On Mar 20, 2012, at 18:37, Ryan Schmidt wrote: > >> On Mar 20, 2012, at 12:39, Dave Curtis wrote: >> >>> david-curtiss-macbook:wxtab dave$ gawk >>> dyld: Library not loaded: /opt/local/lib/libiconv.2.dylib >>> Referenced from: /opt/local/bin/gawk >>> Reason: Incompatible library version: gawk requires version 8.0.0 or later, >>> but libiconv.2.dylib provides version 7.0.0 >>> Trace/BPT trap >> >> The short answer is that you need to rebuild libiconv +universal, or follow >> the Migration instructions if applicable. This has come up so often on the >> list and in the issue tracker since Snow Leopard's release three years ago >> that it's time for me to write a ProblemHotlist entry for it. I'll reply >> here again when I've written it. > > https://trac.macports.org/wiki/ProblemHotlist#libiconv-version > Hmmm... OK, I'll give that a shot. To be honest, I'm not sure of the migration state of this system. I *think* it is correct(*), but this symptom would indicate something is a bit off kilter. I'll try the recommended procedure and see if that helps.
Thanks, Dave * The reason I think I should be good w.r.t. migration is, first off, when I did the original migration from Leopard to Snow Leopard, I *did*attempt to follow the instructions. Then some time later the hard disk seized up and was replaced -- I rebuilt ports on SnowLeopard pretty much from scratch at that point. But... both of those events were a long time ago so my memory is pretty fuzzy. _______________________________________________ macports-users mailing list macports-users@lists.macosforge.org http://lists.macosforge.org/mailman/listinfo.cgi/macports-users
