> OK - so it's possible to append some extra stuff > what else can one put at the end & what's the general format ???
man port
upgrade
The upgrade target works on a port and its dependencies. If you want to
change this behaviour, look at the switches for n (no dependencies) and R
(dependents) below.
Upgrade the installed portname. For example:
port upgrade vim
To upgrade all installed ports:
port upgrade installed
To upgrade portname and the ports that depend on it:
port -R upgrade libiconv
To force an upgrade (rebuild) use:
port upgrade --force vim
To upgrade portname without following its dependencies, use -n. For
example:
port -n upgrade wireshark
Note that in selecting the variants to use in the upgraded build of the
port, any variants specified on the command line take highest precedence,
then the variants active in the latest installed version of the port, and
finally the global variants specified in variants.conf, if any. Note
that upgrade will not normally rebuild a port only to change the selected
variants; you can either specify --enforce-variants, or deactivate the
port and reinstall it with different variants.
After the upgrade MacPorts will automatically run rev-upgrade to check
for broken ports that need to be rebuilt. If there are known problems
with rev-upgrade or other reasons why you would want to avoid running
this step, you can disable it by running port upgrade with the --no-rev-
upgrade switch:
port upgrade --no-rev-upgrade outdated
smime.p7s
Description: S/MIME cryptographic signature
_______________________________________________ macports-users mailing list [email protected] http://lists.macosforge.org/mailman/listinfo.cgi/macports-users
