#438: Determining IP information for ath0... failed.  - Cannot set rate or
encode.
------------------------------+---------------------------------------------
 Reporter:  [EMAIL PROTECTED]  |            Owner:     
     Type:  defect            |           Status:  new
 Priority:  major             |        Milestone:     
Component:  madwifi: other    |          Version:     
 Keywords:  dhcp              |   Patch_attached:  0  
------------------------------+---------------------------------------------
 I have a Netgear PCI card WG311T. The following is an output from lspci:
 Atheros Communications, Inc. AR5212 802.11abg NIC (rev 01)

 uname -r:2.6.15-1.1831_FC4

 I installed the madwifi driver via yum and set up the ath0 device. However
 when I try to obtain an IP through dhcp I get the following errors:

 Error for wireless request "Set Bit Rate" (8B20) :
 SET failed on device ath0 ; Invalid argument.
 Error for wireless request "Set Encode" (8B2A) :
 SET failed on device ath0 ; Invalid argument.

 Determining IP information for ath0... failed.

 I also tried to uninstall the madwifi driver that yum installed and then
 downloaded and compiled the version directly from Madwifi.org. I still get
 the same issue.

 Here is the output for dmesg:

 ath_hal: 0.9.16.16 (AR5210, AR5211, AR5212, RF5111, RF5112, RF2413,
 RF5413)

 wlan: 0.8.4.2 (svn 1457)

 ath_rate_sample: 1.2 (svn 1457)

 ath_pci: 0.9.4.5 (svn 1457)

 ACPI: PCI Interrupt 0000:00:0d.0[A] -> GSI 18 (level, low) -> IRQ 177

 wifi0: 11b rates: 1Mbps 2Mbps 5.5Mbps 11Mbps

 wifi0: 11g rates: 1Mbps 2Mbps 5.5Mbps 11Mbps 6Mbps 9Mbps 12Mbps 18Mbps
 24Mbps 36Mbps 48Mbps 54Mbps

 wifi0: turboG rates: 6Mbps 12Mbps 18Mbps 24Mbps 36Mbps 48Mbps 54Mbps

 wifi0: H/W encryption support: WEP AES AES_CCM TKIP

 wifi0: mac 7.9 phy 4.5 radio 5.6

 wifi0: Use hw queue 1 for WME_AC_BE traffic
 wifi0: Use hw queue 0 for WME_AC_BK traffic
 wifi0: Use hw queue 2 for WME_AC_VI traffic
 wifi0: Use hw queue 3 for WME_AC_VO traffic
 wifi0: Use hw queue 8 for CAB traffic

 wifi0: Use hw queue 9 for beacons

 wifi0: Atheros 5212: mem=0xfde00000, irq=177

-- 
Ticket URL: <http://madwifi.org/ticket/438>
MadWifi <http://madwifi.org/>
Multiband Atheros Driver for Wireless Fidelity

Reply via email to