#1980: ubiquiti 300mW tx-power and sensitivity problem
-------------------------------------+--------------------------------------
Reporter: [EMAIL PROTECTED] | Type: defect
Status: new | Priority: minor
Component: madwifi: driver | Version: v0.9.4
Keywords: | Patch_attached: 0
-------------------------------------+--------------------------------------
ath0 IEEE 802.11g ESSID:"" Nickname:""
Mode:Managed Channel:0 Access Point: Not-Associated
Bit Rate:0 kb/s Tx-Power=19 dBm Sensitivity=1/1
Retry:off RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality=0/70 Signal level=-90 dBm Noise level=-90 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
i have a ubiquity
Ethernet controller: Atheros Communications Inc. AR5212/AR5213
Multiprotocol MAC/baseband processor (rev 01)
i have tried the svn driver and the stable driver and my sensitivity is
very low i cat set the txpower to any value higuer than 19dBm my internal
wlan0 catches 3 accespoints and the ubiquity only catches 1 in the chan 1
my kernel is a 2.6.25.4
on slackware 12.1
--
Ticket URL: <http://madwifi.org/ticket/1980>
madwifi.org <http://madwifi.org/>
Multiband Atheros Driver for Wireless Fidelity
-------------------------------------------------------------------------
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services for
just about anything Open Source.
http://sourceforge.net/services/buy/index.php
_______________________________________________
Madwifi-tickets mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/madwifi-tickets
