#1980: ubiquiti 300mW tx-power and sensitivity problem
------------------------------------------+---------------------------------
      Reporter:  [EMAIL PROTECTED]  |       Owner:        
          Type:  defect                   |      Status:  closed
      Priority:  minor                    |   Milestone:        
     Component:  madwifi: driver          |     Version:  v0.9.4
    Resolution:  invalid                  |    Keywords:        
Patch_attached:  0                        |  
------------------------------------------+---------------------------------
Changes (by mrenzmann):

  * status:  new => closed
  * resolution:  => invalid

Old description:

> ath0      IEEE 802.11g  ESSID:""  Nickname:""
>           Mode:Managed  Channel:0  Access Point: Not-Associated
>           Bit Rate:0 kb/s   Tx-Power=19 dBm   Sensitivity=1/1
>           Retry:off   RTS thr:off   Fragment thr:off
>           Encryption key:off
>           Power Management:off
>           Link Quality=0/70  Signal level=-90 dBm  Noise level=-90 dBm
>           Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
>           Tx excessive retries:0  Invalid misc:0   Missed beacon:0
> i have a ubiquity
> Ethernet controller: Atheros Communications Inc. AR5212/AR5213
> Multiprotocol MAC/baseband processor (rev 01)
> i have tried the svn driver and the stable driver and my sensitivity is
> very low i cat set the txpower to any value higuer than 19dBm my internal
> wlan0 catches 3 accespoints and the ubiquity only catches 1 in the chan 1
> my kernel is a 2.6.25.4
> on slackware 12.1

New description:

 {{{
 ath0      IEEE 802.11g  ESSID:""  Nickname:""
           Mode:Managed  Channel:0  Access Point: Not-Associated
           Bit Rate:0 kb/s   Tx-Power=19 dBm   Sensitivity=1/1
           Retry:off   RTS thr:off   Fragment thr:off
           Encryption key:off
           Power Management:off
           Link Quality=0/70  Signal level=-90 dBm  Noise level=-90 dBm
           Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
           Tx excessive retries:0  Invalid misc:0   Missed beacon:0
 }}}

 i have a ubiquity

 {{{
 Ethernet controller: Atheros Communications Inc. AR5212/AR5213
 Multiprotocol MAC/baseband processor (rev 01)
 }}}

 i have tried the svn driver and the stable driver and my sensitivity is
 very low i cat set the txpower to any value higuer than 19dBm my internal
 wlan0 catches 3 accespoints and the ubiquity only catches 1 in the chan 1

 my kernel is a 2.6.25.4 on slackware 12.1

Comment:

 Regarding TX power: please refer to [wiki:UserDocs/Ubiquity].

 Regarding sensitivity: Please contact our [wiki:Support regular support
 channels]. Thanks.

-- 
Ticket URL: <https://madwifi.org/ticket/1980#comment:1>
madwifi.org <http://madwifi.org/>
Multiband Atheros Driver for Wireless Fidelity
-------------------------------------------------------------------------
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services for
just about anything Open Source.
http://sourceforge.net/services/buy/index.php
_______________________________________________
Madwifi-tickets mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/madwifi-tickets

Reply via email to