Drew- You can't put two thematics on the same layer, but if you were to Add that table again to your layer dialog, you could make a second thematic using it. Your Layer Control would look something like this: >Ind. Value with OrdinalCol Mytable >Ranges by NominalCol Mytable Basetable NOT LIKE... >Ind. Value with OrdinalCol >Ranges by NominalCol Mytable Basetable Good Luck, Jason ���������������������� Jason Adam Computer Draftsperson Monopros Limited Toronto, ON > -----Original Message----- > From: Phillips, Andrew [SMTP:[EMAIL PROTECTED]] > Sent: Thursday, August 19, 1999 10:03 AM > To: mi-l (E-mail) > Subject: MI: Overlay symbols > > I'm trying to show two different attributes of point data, one attribute > ordinal, the other nominal, by varying color and symbol type. Had this > great idea to do so by overlaying thematic maps. Apparently only one > thematic map can be visible at a time, however. Is there another method? > > Drew > > ********************************************************** > Andrew Phillips, Ph.D. 615 E. Peabody St. > Quaternary Geology Section Champaign, IL 61820 > Illinois State Geological Survey (217) 333-2513 (ph) > [EMAIL PROTECTED] (217) 333-2830 (fax) > > > > ---------------------------------------------------------------------- > To unsubscribe from this list, send e-mail to [EMAIL PROTECTED] and put > "unsubscribe MAPINFO-L" in the message body, or contact [EMAIL PROTECTED] ---------------------------------------------------------------------- To unsubscribe from this list, send e-mail to [EMAIL PROTECTED] and put "unsubscribe MAPINFO-L" in the message body, or contact [EMAIL PROTECTED]
