Alan,
I would suggest it is one or more of the DIP switches on your
digitizer. There are user definable switches on digitizing tablet which
let the user set up how the software interprets information from
hardware an vice versa. Since you haven't said that you have changed
anything on the tablet, I would cross check the settings for the tablet
on the tablet, in the digitizer software and in the manual.
What has happened is that in the software, providing you haven't changed
anything on the tablet. Is that the software thinks that the tablet's
control points for upper left / lower left / upper right and lower right
are mixed up. This is in the digitizer set up software. The other
option is that, as I said above the dip switches are making the error.
Stan Johnston
Geologist
Lovett Alan wrote:
>
> Heeeelp,
> I recently have had the misfortune of having to reformat my hard drive and
> have lost a lot of the settings etc. that have been accumulated over time.
> I have reconnected to a digitizer and for some reason the polygons that I
> digitize seem to be a mirror image on the computer screen
>
> eg: a long narrow polygon that runs from north-west to south-east on the
> table appears on the PC as running from north-east to south-west (mirror
> image)
>
> I have checked to make sure that my projections and units are the same and
> have had zero error when registering the info to be digitized. Can any one
> shed some light as to what I am doing incorrectly.
>
> cheers
>
> Alan Lovett
> ----------------------------------------------------------------------
> To unsubscribe from this list, send e-mail to [EMAIL PROTECTED] and put
> "unsubscribe MAPINFO-L" in the message body, or contact [EMAIL PROTECTED]
----------------------------------------------------------------------
To unsubscribe from this list, send e-mail to [EMAIL PROTECTED] and put
"unsubscribe MAPINFO-L" in the message body, or contact [EMAIL PROTECTED]
