Just upgraded to v 6.0. Good news, bad news. I can now view ER Mapper
images, but...
A few things have come to my attention so far. First, I am unable to modify
a thematic map saved in a v 4.1.2 workspace, even if I save it in v 6. I
open the legend...styles and change the colour of an individual value.
Change colour...OK...OK... and the colour on the map reverts to what it was.
I had to edit the .wor and open in 4.1.2 to modify.
Second, even tho' MI 6 saves printer info in a workspace, it does not
display this in a layout when re-opened. I have a LaserJet set as the
default printer on my PC. When I create a workspace with a layout, set up
to use the roll feed DesignJet (36 "), the next time I open the workspace,
it shows default printer settings.
Third. I prefer to do the page setup before I create a layout. However,
with MI 6, the page setup doesn't "take". If I do page setup for a large
sheet and set the printer, then when I create the layout, it shows the
default laser jet settings.
Any ideas?
"There are no bugs, only future enhancement opportunities"
Gerald Kornelsen
----------------------------------------------------------------------
To unsubscribe from this list, send e-mail to [EMAIL PROTECTED] and put
"unsubscribe MAPINFO-L" in the message body, or contact [EMAIL PROTECTED]
