will this do what you want??
"Create Object As ConvexHull From Selection Into Table Whatever"
(table must be open)
then you can select that object, convert to polylines, then smooth
polylines, and you'll have a nice roundy looking thing around your objects
(may not enclose extremety objects due to smoothing, just enlarge object)
ash
-----Original Message-----
From: Chris Loty [mailto:[EMAIL PROTECTED]]
Sent: Tuesday, 17 September 2002 1:41 PM
To: Directionsmag. . . . . (E-mail)
Subject: MI-L areas from points.....
If i have selected points and they are located as bunches of points in
different areas. How do i put an area (polygon) around each of the bunches
??
regards
Chris Loty
Wind Business Project Officer
Sustainable Energy Development Authority
(w) 9249 6192 (f) 9299 1519
http://www.seda.nsw.gov.au
This message is intended for the addressee named and may contain
confidential information. If you are not the intended recipient, please
delete it and notify the sender. Views expressed in this message are those
of the individual sender, and are not necessarily the views of SEDA.
The sender cannot guarantee that this email or any attachment to it is free
of computer viruses or other conditions which may damage or interfere with
data, hardware or software with which it might be used. It is sent on the
strict condition that the user carries out and relies on its own procedures
for ensuring that its use will not interfere with the recipient's systems
and the recipient assumes all risk of use and absolves the sender of all
responsibility for any consequence of its use.
---------------------------------------------------------------------
List hosting provided by Directions Magazine | www.directionsmag.com |
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
Message number: 3073
---------------------------------------------------------------------
List hosting provided by Directions Magazine | www.directionsmag.com |
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
Message number: 3075
