I think that with at least 6.5 the only unit available for saving a layout in a workspace is "in". This was discussed long time ago and never got the attention (or rather the action it requires) of MI.
Jacques Paris e-mail [EMAIL PROTECTED] MapBasic-MapInfo support http://www.paris-pc-gis.com -----Original Message----- From: Thomas Brix Lyng [mailto:[EMAIL PROTECTED]] Sent: February 20, 2003 07:24 To: MapInfo-L@lists. directionsmag. com (E-mail) Subject: MI-L Workspace Units Hi all I have a problem getting MapInfo 6.5 to accept that I wan't the units of my saved workspaces to be "cm" (Centimetres) and not "in". I have been through every setting in MapInfo with no luck. When I doubleclick a frame in my layoutwindow I get the size in "cm" but when I save the workspace and edit it with textpad it is in inces! I have tried: Set Paper Units "cm" before saving a workspace with one mapper and a layout but MapInfo still writes the workspace units in inces. Please advice. Regards Thomas Brix Lyng Frederikshavn Denmark --------------------------------------------------------------------- List hosting provided by Directions Magazine | www.directionsmag.com | To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] Message number: 5592 --------------------------------------------------------------------- List hosting provided by Directions Magazine | www.directionsmag.com | To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] Message number: 5593
