Hi Everyone, I'm developing an application using VB and MapX, which is showing strange behaviour whilst the users are digitizing. Basically, they add a line, the map refreshes itself and the raster basemap isn't displayed in the same place anymore. It's usually only a small offset, but I have seen it offset by about 1cm on the screen at times. Zooming out, then back in again fixes the problem. has anyone seen anything similar? More to the point, has anyone got any ideas on how to stop it happening? MapX 5, VB 6. Maps are seamless TIFF or ECW files, British National Grid projection. TIA Dave.
File Ref: /DGS/DJB/Project Number/Filename --------------------------------------------- Dr. David Booth Principal GIS Officer Mott MacDonald Merseyside Information Service 325 Royal Liver Building Pier Head, Liverpool L3 1JH Tel (0151) 236 4343 (Reception) Tel 0151 243 1369 (Direct Line) Fax (0151) 236 2521 <file:///C:/Documents%20and%20Settings/DavidB/Application%20Data/Microsoft/S ignatures/www.merseyinfoserv.com> www.merseyinfoserv.com This document has been prepared for the titled project or named part thereof and should not be relied upon or used for any other project without an independent check being carried out as to its suitability and prior written authority of Mott MacDonald being obtained. Mott MacDonald accepts no responsibility or liability for the consequence of this document being used for a purpose other than the purposes for which it was commissioned. Any person using or relying on the document for such other purpose agrees, and will by such use or reliance be taken to confirm his agreement to indemnify Mott MacDonald for all loss or damage resulting therefrom. Mott MacDonald accepts no responsibility or liability for this document to any party other than the person by whom it was commissioned.
