Hello, I have a table that I have just created Lat/Longs for using the process CentroidY(obj) command for Latitude and CentroidX(obj) for Longitude and creating each as type "float". The resulting figures only have the Latitude to four decimal places but I require it to six and was wondering if there was a way I could amend this or if I re-create the table what should I change in my current process?
Regards, Sarah *********************************************************************************** The contents of the e-mail and any transmitted files are confidential and intended solely for the use of the individual or entity to whom they are addressed. Transport for London hereby exclude any warranty and any liability as to the quality or accuracy of the contents of this email and any attached transmitted files. If you are not the intended recipient be advised that you have received this email in error and that any use, dissemination, forwarding, printing or copying of this email is strictly prohibited. If you have received this email in error please notify [EMAIL PROTECTED] This footnote also confirms that this email message has been swept for the presence of computer viruses. *********************************************************************************** --------------------------------------------------------------------- List hosting provided by Directions Magazine | www.directionsmag.com | To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] Message number: 10202
