I am brand new to vertical mapper (in fact I have just been handed the
manual). Please correct me if I am wrong, but it appears as if you can't
take a line table with a attribute for height and either use this in VM,
or, convert this to a point table to then use in VM.
My question is: does anyone have a mbx, they would be willing to share,
that takes a polyline and creates points at intervals along it and gives
the point the height attribute that was on the polyline?
Any and all wisdom greatly appreciated.
Thanks
Andrew Buchanan
Sewerage Group
Melbourne Water
Melbourne
AUSTRALIA
PLEASE NOTE
This message is for the stated recipient only
and not to be passed on to a third party without
the approval of Melbourne Water.
----------------------------------------------------------------------
To unsubscribe from this list, send e-mail to [EMAIL PROTECTED] and put
"unsubscribe MAPINFO-L" in the message body, or contact [EMAIL PROTECTED]
