Brent Herring <[EMAIL PROTECTED]> wrote:
>
> I'm trying to setup diald, and having problems.
I don't use diald, and never have, so I can't offer any ideas. I use
pppd's "demand" mode to do my auto-dialing.
> When I connect manually I can run "route" and see all my routing
> information, but when diald dials route just hangs up and never shows
> any information.
It's not hanging forever; it is trying to send out DNS requests.
Whenever you are troubleshooting a network, the "-n" option on mosts
commands is your best friend.
"route -n", "netstat -n", "ipchains -L -n", etc.
> does anyone have any helpful suggestions about what might be causing
> this to occur?
Diald uses a route through a "pseudo-slip" interface, right? If so,
shouldn't it be removing that route and replacing it with a default
route through the ppp interface that just came up? I dunno.
Perhaps your IP Masq firewall stuff is getting in the way when it gets
configured in /ec/ppp/ip-up? Or is this a masq question at all? You do
know what mailing list this is, right? ;)
--
[EMAIL PROTECTED] (Fuzzy Fox) || "Nothing takes the taste out of peanut
sometimes known as David DeSimone || butter quite like unrequited love."
http://www.dallas.net/~fox/ || -- Charlie Brown
_______________________________________________
Masq maillist - [EMAIL PROTECTED]
http://tiffany.indyramp.com/mailman/listinfo/masq
Admin requests can be handled by web (above) or [EMAIL PROTECTED]
