Hai Oguzhan,
Just type >*runpf('case300')* in matlab command window. If you need the Ybus
and all other variables in between you can get it by using *disp(Ybus)* in
126 th line of runpf.m file.
So it may be the problem with using int2ext.m and ext2int.m. These are used
for Bus number conversion.
On Thu, Feb 5, 2009 at 10:10 PM, <[email protected]> wrote:
> Hi everyone,
>
> I am a phd student from Istanbul Technical University, Turkey.
> I have a simple question.
>
> makeYbus function works well in IEEE 14 bus test case, IEEE 30
> bus test case, IEEE 57 bus test case, and IEEE 118 bus test case.
> In IEEE 300 bus test case it gives an error as shown below:
>
> "buses must appear in order by bus number"
>
> I controlled case300.m file and i saw that the buses are not really
> in order. After bus 250 the bus numbering changes. Can anyone offer
> me any solution to this problem? Or am i doing something wrong?
>
> Thank you very much
> Oguzhan
>
>
> --
> This message has been scanned for viruses and
> dangerous content by MailScanner, and is
> believed to be clean.
>
>
>
-----------------------------------------------------------
WITH REGARDS,
V.RAVIKUMAR PANDI,
Research Scholar,
Dept. of Electrical Engg,
IIT Delhi, New Delhi
-------------------------------------------------------------
HAVE A NICE DAY
-------------------------------------------------------------
