Hey Durga, I have once used Simulink for doing such measurement. I wrote a paper and training material (did that as part of a project called "Development of a simulation methodology for power quality issues"), but is all in Portuguese (I am Brazilian). If you still think you could use that, let me know and I can try to find that for you.
Regards, Vinícius José Lindolpho Antunes On Wed, Oct 14, 2009 at 9:29 PM, Durga Reddy <[email protected]>wrote: > @ Dirk, Thank you so much. Basically am signal processing student, so bit > new to power systems. Am looking for some programming model to obtain the > harmonic voltage measurements at a particular bus for standard IEEE 14-bus > system. > Thanks > > ------------------------------ > *From:* Dirk Van Hertem <[email protected]> > *To:* MATPOWER discussion forum <[email protected]> > *Sent:* Wed, October 14, 2009 7:04:27 PM > *Subject:* Re: Harmonic voltage measurement > > Durga Reddy wrote: > > Hi, > > It will be great if someone could give me the procedure for > > harmonic voltage measurement at particular bus using MATPOWER. > > Thanks, > > Durga > > > I do not think you know what matpower is or what a harmonic voltage > measurement is. Matpower is a program for steady state analysis of > electric power systems, typically using the load flow equations or an > optimization algorithm around them. Matpower works with a single > frequency, the rated one. Matpower also is a simulation tool, not a > measurement tool... > > Dirk > > -- > Dirk Van Hertem [email protected] > Electrical Engineering Department http://www.esat.kuleuven.be/electa > K.U. Leuven, ESAT-ELECTA tel: +32-16-32.18.95 > 10, Kasteelpark Arenberg, B-3001 Heverlee fax: +32-16-32.19.85 > > > >
