Dear Claire, You need to convert all the data into per unit values. Then insert them into the matpower data. But, you need the put the correct voltage values for the base case.
Associate Professor Dr. Ismail Musirin (MIEEE, -PES, -CIS, -CMCS, ARTIST, IAENG) Deputy Dean (Research & Industrial Network) Faculty of Electrical Engineering Universiti Teknologi MARA 40450 Shah Alam, Selangor MALAYSIA Tel: 603-55435044 or 6012-6603864 Fax: 603-55435044 ________________________________ From: gsh <[email protected]> To: [email protected]; [email protected] Sent: Thu, 17 December, 2009 15:46:48 Subject: RE: power flow for radial distribution feeders (distribution grid) Dear Dr. Musirin: Thank you for your help! The case format provided in the MATPOWER is correspongding to IEEE trisimission system data, including 14 bus, 30 bus... test system. But the distribution feeder is based on a different model that is illustrated in the following website (data of 13 node, 34 node ... feeders). http://www.ewh.ieee.org/soc/pes/dsacom/testfeeders.html How can I input this set of date for distribution feeder into the MATPOWER case? Best regards, Claire ________________________________ Date: Wed, 16 Dec 2009 21:13:17 -0800 From: [email protected] Subject: Re: power flow for radial distribution feeders (distribution grid) To: [email protected]; [email protected] Hi Claire, Yes, you should be able to do it using Matpower. However, you should look at the bus coding because, distribution system has only one generator bus. Good luck. Associate Professor Dr. Ismail Musirin (MIEEE, -PES, -CIS, -CMCS, ARTIST, IAENG) Deputy Dean (Research & Industrial Network) Faculty of Electrical Engineering Universiti Teknologi MARA 40450 Shah Alam, Selangor MALAYSIA Tel: 603-55435044 or 6012-6603864 Fax: 603-55435044 ________________________________ From: gsh <[email protected]> To: [email protected] Sent: Thu, 17 December, 2009 10:55:20 Subject: power flow for radial distribution feeders (distribution grid) Dear Friends, I find there are two types of IEEE test systems for power system analysis. One is IEEE radial test feeders for distribution system analysis. The other is non-radial test feeder, which is used to test power system analysis for transmission system level. The example cases provided by MATPOWER in power flow solution are transmission systems. Is MATPOWER capable to solve power flow for radial distribution feeders? I try to perform a distribution grid power flow program. Could I use the data for distribution system in the MATPOWER routine? Best regards, Claire ________________________________ 使用Messenger保护盾2.0，支持多账号登录！ 现在就下载！ ________________________________ 聊天+搜索+邮箱 想要轻松出游,手机MSN帮你搞定! 立刻下载！ ________________________________ 聊天+搜索+邮箱 想要轻松出游,手机MSN帮你搞定! 立刻下载！
