Thank you Sir. I'll go into the details. On Mon, Oct 20, 2014 at 12:54 PM, Abhyankar, Shrirang G. < [email protected]> wrote:
> Abhishek, > Please read my reply carefully. I said you need to provide basecasedata > __AND__ targetcasedata. > > Shri > > From: abhisek mishra <[email protected]> > Reply-To: MATPOWER discussion forum <[email protected]> > Date: Mon, 20 Oct 2014 12:37:36 -0700 > To: MATPOWER discussion forum <[email protected]> > Subject: Re: problem in continuation load flow > > Thanx sir for your concern. I did provide base case data. I tried with > "runcpf('case_ieee30') " & "runcpf(case14)"... Still m getting error. > > On Mon, Oct 20, 2014 at 12:33 PM, Abhyankar, Shrirang G. < > [email protected]> wrote: > >> Abhishek, >> You have to provide the 'basecasedata' and 'targetcasedata' (run 'help >> runcpf' for the meaning of these terms) for runcpf. If no targetcasedata is >> provided to runcpf then it assumes that the base case is case9.m and uses >> an example targetcasedata created for this case. It will be also helpful >> for you to read the section on 'Continuation Power Flow' in the MATPOWER >> manual. >> >> Shri >> >> From: abhisek mishra <[email protected]> >> Reply-To: MATPOWER discussion forum <[email protected]> >> Date: Mon, 20 Oct 2014 11:05:56 -0700 >> To: <[email protected]> >> Subject: problem in continuation load flow >> >> Dear all; >> >> I am facing problem in continuation load flow. >> Whenever I simply type "runcpf" it works(for 9 bus system); but when I >> try it for IEEE 30 bus system/ 14 bus system, it shows error at line 213. >> >> Please help me. >> >> >> *Regerds* >> >> *Abhisek * >> >> >
