Hi all
I’ve set all generators’ cost to be the same and left the voltage magnitude,
angle and the Pgen Qgen empty for all buses. I then run an OPF and got an error.
I wish to obtain the voltage magnitude, angle, and Pgen Qgen for each bus using
this method. Is it possible?
Also, what other ways can i take to get the 4 parameters for my case?
Best
Zeya
---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Disclaimer:
This message (including any attachments) contains confidential information
intended for a specific individual and purpose. If you are not the intended
recipient, you should delete this message and notify the sender and The Hong
Kong Polytechnic University (the University) immediately. Any disclosure,
copying, or distribution of this message, or the taking of any action based on
it, is strictly prohibited and may be unlawful.
The University specifically denies any responsibility for the accuracy or
quality of information obtained through University E-mail Facilities. Any views
and opinions expressed are only those of the author(s) and do not necessarily
represent those of the University and the University accepts no liability
whatsoever for any losses or damages incurred or caused to any party as a
result of the use of such information.
