Hi Ray,
I am a new user of MATPOWER and MATACDC ana a Ph.D student @
University of Manitoba. I have downloaded and installed MATPOWER 4.1
with Matlab version 7.10.
I am working with IEEE 39 bus case and noted that there is a
discrepancy in terms of loads at buses with the data I have from
http://publish.illinois.edu/smartergrid/ieee-39-bus-system/ and that
in case39. The same has been highlighted in some postings here too.
I have 3 simple questions:-
Q1. A very basic one - When I enter data in the bus struct the value
for Vm and Va can be 1 and 0 respectively. Since the Volt. magnitude
and Volt. angle will be computed by load flow. (As I understand).
Q2. I did enter the data as provided in the Univ. of Illinois site
mentioned above and I found that my case did not converge?
Q3. Is it possible to find the eigenvalues of AC-DC system using MATPOWER?
Since I am working with this data can you please throw some light as
to how I can resolve the issue. I will be very grateful.
--------------------------
Rajesh Vaid
