Oh yes. Forgot. Thanks.
From: [email protected]
[mailto:[email protected]] On Behalf Of Ray Zimmerman
Sent: Tuesday, 1 May, 2018 8:43 PM
To: MATPOWER discussion forum
Subject: Re: DC OPF reference voltage
Almost. The angle at the reference bus is take to be whatever is specified in
the bus matrix, which need not be zero.
Ray
On May 1, 2018, at 3:19 AM, Sarmad Hanif
<[email protected]<mailto:[email protected]>> wrote:
Voltage magnitudes are assumed to be 1 p.u., whereas the slack bus (type = 3)
in the case file is chosen as the reference. Hence, the angle at the slack bus
is then also taken as 0.
Hope it helps.
-----Original Message-----
From:
[email protected]<mailto:[email protected]>
[mailto:[email protected]] On Behalf Of Stefanie Aebi
Sent: Tuesday, 1 May, 2018 2:13 PM
To: [email protected]<mailto:[email protected]>
Subject: DC OPF reference voltage
Hi
I wonder how DC OPF is handled. Since in the linearization only differences in
voltages appear, is there a reference voltage set? And how is that reference
voltage chosen?
Thanks!
