We stuck at this point. Any tip is welcomed. Regards, Mahmood
----- Original Message ----- From: Mahmood Naderan <[email protected]> To: torque cluster <[email protected]> Cc: Sent: Friday, October 12, 2012 8:54 PM Subject: [torqueusers] problem with torque 4.1 (Cannot connect to default server) Dear all, Below is our procedure to configure torque 4.1. However at the end we got an error. 1- compile and install torque 2- put the server hostname (archie) in the /var/spool/torque/server_name 3- put the server hostname in the /var/spool/torque/server_priv/nodes file. This is a shared memeory machine so the server and client are the same machine 4- run the command "pbs_server -t create" to setup the pbs_server 5- run the command "qmgr -c 'p s'" and the following error is reported Error communicating with archie(192.160.1.100) Cannot connect to default server host 'archie' - check pbs_server daemon and/or trqauthd. qmgr: cannot connect to server (errno=111) Connection refused 6- starting trqauthd does not change the state and the error is reported again on submitting qmgr -c 'p s' Any comment is appreciated. Regards, Mahmood _______________________________________________ torqueusers mailing list [email protected] http://www.supercluster.org/mailman/listinfo/torqueusers _______________________________________________ mauiusers mailing list [email protected] http://www.supercluster.org/mailman/listinfo/mauiusers
