You need to kill pbs_server with "kill -9". It does not shut down correctly.
On 14 October 2012 16:22, Mahmood Naderan <[email protected]> wrote: > We stuck at this point. Any tip is welcomed. > > > Regards, > Mahmood > > > > ----- Original Message ----- > From: Mahmood Naderan <[email protected]> > To: torque cluster <[email protected]> > Cc: > Sent: Friday, October 12, 2012 8:54 PM > Subject: [torqueusers] problem with torque 4.1 (Cannot connect to default > server) > > Dear all, > > > Below is our procedure to configure torque 4.1. However at the end we got > an error. > > 1- compile and install torque > 2- put the server hostname (archie) in the /var/spool/torque/server_name > 3- put the server hostname in the /var/spool/torque/server_priv/nodes > file. This is a shared memeory machine so the server and client are the > same machine > 4- run the command "pbs_server -t create" to setup the pbs_server > 5- run the command "qmgr -c 'p s'" and the following error is reported > > Error communicating with archie(192.160.1.100) > Cannot connect to default server host 'archie' - check pbs_server daemon > and/or trqauthd. > qmgr: cannot connect to server (errno=111) Connection refused > > 6- starting trqauthd does not change the state and the error is reported > again on submitting qmgr -c 'p s' > > > Any comment is appreciated. > > Regards, > Mahmood > _______________________________________________ > torqueusers mailing list > [email protected] > http://www.supercluster.org/mailman/listinfo/torqueusers > > _______________________________________________ > torqueusers mailing list > [email protected] > http://www.supercluster.org/mailman/listinfo/torqueusers > -- Clotho Tsang Senior Software Engineer Cluster Technology Limited Email: [email protected] Tel: (852) 2655-6129 Fax: (852) 2994-2101 Website: www.clustertech.com
_______________________________________________ mauiusers mailing list [email protected] http://www.supercluster.org/mailman/listinfo/mauiusers
