I am trying to figure out if it's possible to hard code some values in the task sequence wizard. I would like to hardcode the 'configure proxy settings' along with some items under the 'configure network settings'. I was going to use netsh to do most of the tasks, but the winpe netsh does not support winhttp command for proxy configuration.
[http://social.technet.microsoft.com/Forums/getfile/425869] Thanks, Eric ________________________________ CONFIDENTIALITY NOTICE: This email contains information from the sender that may be CONFIDENTIAL, LEGALLY PRIVILEGED, PROPRIETARY or otherwise protected from disclosure. This email is intended for use only by the person or entity to whom it is addressed. If you are not the intended recipient, any use, disclosure, copying, distribution, printing, or any action taken in reliance on the contents of this email, is strictly prohibited. If you received this email in error, please contact the sending party by reply email, delete the email from your computer system and shred any paper copies. Note to Patients: There are a number of risks you should consider before using e-mail to communicate with us. See our Privacy & Security page on www.henryford.com for more detailed information as well as information concerning MyChart, our new patient portal. If you do not believe that our policy gives you the privacy and security protection you need, do not send e-mail or Internet communications to us.
<<inline: image003.jpg>>
