Ya, we are using the docking station. When it loads WinPE and I open up F8, I do have an IP address.
On Mon, Aug 29, 2016 at 10:21 AM, Keith Garner (Hotmail) < [email protected]> wrote: > If it can’t connect to the DeployRoot/Deployment share it would suggest to > me that you don’t have the right network driver installed. Also I don’t > think the Dell Venue 11 pro has a on-board nic, so you would either need to > use the Docking Station or use a USB-NIC adapter. > > > > Standard Network troubleshooting applies here. Also: How to Debug > missing Drivers in MDT Litetouch > <https://social.technet.microsoft.com/Forums/en-US/3e083173-f5db-48e9-b744-f71b9ca6541c/how-to-debug-missing-drivers-in-mdt?forum=mdt> > > > > -k > > > > *From:* [email protected] [mailto:listsadmin@lists. > myitforum.com] *On Behalf Of *Adam Juelich > *Sent:* Monday, August 29, 2016 7:46 AM > *To:* [email protected] > *Subject:* [MDT-OSD] DeployRoot not found > > > > Hello Everyone, > > > > Let me preface this that I'm not a huge MDT guy. My OSD experience in the > last 6 years has strictly been through ConfigMgr. I just started a new job > and they have MDT 2012 in place and we are moving to ConfigMgr in a few > months. I want to eventually utilize MDT more but I do not have a lot of > time right now. I'd like to update their MDT instance and utilize the > Windows 10 1607 ADK but since we will only be using it for a few > more months I'm thinking about leaving well-enough alone... > > > > We are trying to image a Dell Venue 11 Pro with Windows 7......I know, > doesn't make much sense but that is what is standardized right now. They > have two boot images available, one is the LiteTouch and the other is one > from the Windows 8 ADK. It boots to the Windows 8 one, runs the bootstrap > settings, but then states that it cannot connect to the > DeployRoot/DeploymentShare. If I do a 'pushd' to that UNC path after > bringing up the Diagnostic Command Prompt, it cannot connect to it. > > > > I re-created the Task Sequence for that model as, initially, they were > receiving an unattend error. > > > > On other models, the LiteTouch Boot Image works just fine and they should > both be utilizing the same bootstrap.ini file. > > > > Any ideas? > > > > Thanks! >
